Aftermarket EFI question, injector sizes? |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Aftermarket EFI question, injector sizes? |
jhadler |
Dec 14 2005, 03:47 PM
Post
#1
|
Long term tinkerer... Group: Members Posts: 1,879 Joined: 7-April 03 From: Lyons, CO Member No.: 529 |
For those who have installed aftermarket EFI systems, what size injectors would you recommend for what is basically a stock 2.0L four-banger?
-slightly- higher compression than stock, with headers and I/R throttles. The basic calculations I did say that 17# is enough, so I figure some nice Ford 19# injectors would be just fine. Am I off base here? Thanks -Josh2 |
Brett W |
Dec 14 2005, 08:16 PM
Post
#2
|
Advanced Member Group: Members Posts: 2,856 Joined: 17-September 03 From: huntsville, al Member No.: 1,169 Region Association: None |
I don't know about the Bosch injectors but the Honda injectors are peak hold types that flow 240cc. They will handle well over two hundred HP on an engine that is much more efficient than the stock T4. You can ususally pick them up for about 25-50$. Peak Holds react much faster than saturated types. They will idle better and open and close faster. Although not really important for stock NA motor using small injectors, when going to 500-1000cc injectors you have to have some that respond very quickly to get it to idle.
|
Lo-Fi Version | Time is now: 11th June 2024 - 08:55 PM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |