 Checking spring rate, Am I doing it right? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| bondo |
 Jan 8 2006, 09:17 PM
Post
#1
|
|
Practicing my perpendicular parking  Group: Members Posts: 4,277 Joined: 19-April 03 From: Los Osos, CA Member No.: 587 Region Association: Central California  |
I set the spring with a metal plate on it next to a wall. I made a mark on the wall at the top of the plate. I added 25 lbs, 50 lbs, and 230 lbs (me), and marked the wall accordingly. I then did the math to calculate pounds per inch, and I get around 120 lbs per inch. (for example, it deflected 1.9 inches when I stood on it)
All the measurements started with a nearly completely unloaded spring, which is not the situation it will see in a car. Is the spring effect linear, or do I need to install them in a 914 and see how much it dips when I jump in the rear trunk? |
   |
 
|
  |
Replies
| bondo |
Jan 17 2006, 04:53 PM
Post
#2
|
||||
|
Practicing my perpendicular parking Group: Members Posts: 4,277 Joined: 19-April 03 From: Los Osos, CA Member No.: 587 Region Association: Central California |
I have a pic to post when I get home.. You WILL laugh. That is what I did, but it wasn't nearly as elegant. Besides my geekiness, doesn't it look more like a 120-130 lb spring than a 180? |
||||
|
|
|
||||
Posts in this topic
bondo Checking spring rate Jan 8 2006, 09:17 PM
SirAndy Jan 8 2006, 10:38 PM bondo http://www.914world.com/bbs2/ht... Jan 9 2006, 10:00 AM Borderline That's the principle. You should be in the ba... Jan 9 2006, 10:09 AM bondo ... Jan 9 2006, 11:01 AM ppickerell Aaron is right. Get the spring under some load at ... Jan 9 2006, 11:29 AM bondo Jan 9 2006, 12:09 PM ppickerell Ooops, My bad, the springs I make are so f'in ... Jan 9 2006, 12:27 PM bondo Ok, I tried it with more weight. I added weight in... Jan 17 2006, 04:17 PM Mueller Jan 17 2006, 04:31 PM Mueller Jan 17 2006, 04:57 PM bondo <... Jan 17 2006, 05:29 PM bondo I think I may have figured out where the 1/4" come... Jan 17 2006, 06:59 PM bondo Ok, here's the pic.. this is 300 lbs. Half the... Jan 17 2006, 07:28 PM bondo Ok, I measured the spring and used this formula to... Jan 20 2006, 06:19 PM
bondo Here is the graph of the data. (I did the graph a ... Jan 20 2006, 06:22 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd April 2026 - 03:36 PM |
Invision Power Board
v9.1.4 © 2026 IPS, Inc.