Help! Calling Red Beard, (or someone who knows 6 tailshift linkag |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Help! Calling Red Beard, (or someone who knows 6 tailshift linkag |
Porsche Rescue |
Aug 29 2003, 04:48 PM
Post
#1
|
Saving and Enjoying Old Porsches Group: Members Posts: 2,978 Joined: 31-December 02 From: Bend, Oregon Member No.: 64 Region Association: None |
Replacing all bushings in my six shift linkage (2 out of 4 are still there, none in firewall or tunnel). My only experience is with 4's and side shift conversion in a six. It appears I must remove roll pin at tranny end of rear rod to remove the bracket so as to install new plastic (right?).
Can I reuse the pin? Probably not. Remember reading somewhere that not just any old hardware store roll pin will do. Where to get the replacement? Porsche NA? |
Red-Beard |
Aug 31 2003, 09:04 PM
Post
#2
|
"Ya canna change the laws of Physics" Group: Benefactors Posts: 1,124 Joined: 11-February 03 From: Houston, TX Member No.: 288 Region Association: None |
That one isn't, but I can send you one, as the gasket set comes with eveyrthing and side shifter's don't use that one.
You can also buy gasket material from any FLAPS and trace the old gasket on there and cut with an exacto knife. |
Lo-Fi Version | Time is now: 16th June 2024 - 06:52 AM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |