 New clutch doesn't fit., Why, oh why!!! |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| LowGT |
 Feb 7 2006, 09:34 PM
Post
#1
|
|
1.8 and Proud!  Group: Members Posts: 583 Joined: 2-October 05 From: Wylie, TX Member No.: 4,904 Region Association: Southwest Region  |
Finally got the engine back together and I was putting the flywheel/clutch/pressure plate back on when... I tried to put the clutch disc into the flywheel and it's too big by about 2 mm. It's part number PCG-116-011-05 from pelican. The disc splines onto the tranny and clutch alignment tool fine, but too big for the flywheel.
Do I have a bus flywheel or something? |
   |
 
|
  |
Replies
| Tom Perso |
Feb 8 2006, 06:55 AM
Post
#2
|
|
Crazy from the Cold... Group: Members Posts: 647 Joined: 8-August 03 From: Kalamazoo, MI Member No.: 1,003 |
You have a 210mm Bus flywheel on your engine. I'd swap everything out with 914 stuff since your 901 trans depends on the bushing/bearing being in the flywheel. Like Andy said, check the runout of your input shaft.
You may have caught it in time. You might get lucky and swap the whole flywheel/PP combo with a fellow T4 owner who is looking to stick a 914 motor into a Bug or Bus. They'll need your 210mm flywheel and such since the 914 parts won't fit a T1 trans. Good Luck, Tom |
|
|
|
Posts in this topic
LowGT New clutch doesn't fit. Feb 7 2006, 09:34 PM
dmenche914 Got a measurement you can give us on the flywheel ... Feb 7 2006, 09:45 PM tat2dphreak http://www.914world.com/bbs... Feb 7 2006, 09:50 PM LowGT New clutch = 215.9mm
Old clutch = 209.55mm
Open... Feb 7 2006, 10:01 PM LowGT From the best I can tell, the marking on the back ... Feb 7 2006, 10:44 PM SirAndy Feb 7 2006, 11:31 PM LowGT Feb 7 2006, 11:50 PM SirAndy Feb 7 2006, 11:59 PM LowGT Interesting, I pulled my eng/trans because I was f... Feb 8 2006, 12:20 AM SirAndy Feb 8 2006, 12:24 AM Series9 Once upon a time, I had a 914 w/bus flywheel.
I d... Feb 8 2006, 12:37 AM LowGT Feb 8 2006, 01:09 AM
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st June 2024 - 01:18 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.