will rear 914 6 hubs work w/ 914 4 axle shafts? Options

[pnewman]

Sorry for the newbie question. I am looking at putting a pair of 914 6 rear swing arms on my 914 4 lugger to do the 5 lug conversion thing and was concerned about the 4 bolt axle shafts fitting through the hubs.

I am sure this is a no brainer for you guys.

thanks, Pete

[Eric_Shea]

Handbrake cable... correct! (thanks)

If I recall, it was a strip of cloth around the cable and a screw that went into that tab. Very sophisticated... and as stated, they're on a ton of 914 control arms. About 3/4" wide and 1.5" tall.

Now... if someone wants a rare 914-6 left control arm, let me know. I'll set one aside for you. Suggested list $300. 914club Special $250.

But wait! 5% off for club members for the next week!! $237.50 shipped right to your door!

* Offer not valid in certain mountanoius areas of California where only strange men and small furry creatures would venture. 914-6 hub not included. Offer only good upon availability. All I can say is "they're In-Stock" now but by the time you order they may not be. We reserve the right to ship a lame regular 914-4 left control arm and charge a minimum order fee of $50.00 for any orders under $10,000.00. If there is a problem with your order we promise the problem will be on your end. We state this upfront so you are aware of our customer service policy (or lack thereof).