 Flywheel removal, anything special I need to do |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| ventilator01 |
 Feb 19 2006, 12:09 PM
Post
#1
|
|
Member  Group: Members Posts: 127 Joined: 22-November 05 From: Thomaston, Ga 30286 Member No.: 5,166  |
Im to the point in my teardown that I need to remove the flywheel, this part is not covered in the video I bought, do I need to make any reference markings before I start unbolting?
Thx steve Attached image(s) 
|
   |
 
|
  |
Replies
| rhodyguy |
Feb 19 2006, 01:13 PM
Post
#2
|
|
Chimp Sanctuary NW. Check it out. Group: Members Posts: 22,084 Joined: 2-March 03 From: Orion's Bell. The BELL! Member No.: 378 Region Association: Galt's Gulch |
there is a flywheel lock tool that helps. can't find mine right now so no picture. they're shown at pelican. you will need to get the spline alignment tool for reassem. most bug shops will have them, pretty cheap too. a compressor and impact gun makes short work of the removal.
k |
|
|
|
Posts in this topic
ventilator01 Flywheel removal Feb 19 2006, 12:09 PM
tat2dphreak no ref. marks unless you are going to re-use the p... Feb 19 2006, 01:00 PM tat2dphreak ... Feb 19 2006, 01:34 PM mack914 I had to apply a little heat to those bolts....to ... Feb 19 2006, 01:39 PM rhodyguy you're an animal wayne http://w... Feb 19 2006, 01:40 PM tat2dphreak jab the screwdriver through the hole in the case..... Feb 19 2006, 01:50 PM KevinP Steve,
I always make it a habit to index everythi... Feb 19 2006, 02:01 PM
ventilator01 Thx everyone, I have it off, I had to use about ... Feb 19 2006, 02:46 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st June 2024 - 12:43 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.