New Terry Cable BROKE Options

[Kerrys914]

(IMG:http://www.914world.com/bbs2/html/emoticons/headbang.gif) (IMG:http://www.914world.com/bbs2/html/emoticons/headbang.gif) (IMG:http://www.914world.com/bbs2/html/emoticons/ar15.gif) (IMG:http://www.914world.com/bbs2/html/emoticons/ar15.gif)

Last weekend I broke my year old throttle cable (IMG:http://www.914world.com/bbs2/html/emoticons/mad.gif) I decided to order a Terry Cable (best out there?) from PParts.

The cable came in on Thursday (very good shipping time from CA to VA). I installed the cable today..too longer then I thought it would. It was a pain to remove the A/C console, pedal board, and snake the cable in while the car wa on all 4's. (IMG:http://www.914world.com/bbs2/html/emoticons/dry.gif)

After adusting the cable so I had full open and the pedal stop so I would stretch the cable. I figured I was done. As I was depressing the pedal by hand SNAP (IMG:http://www.914world.com/bbs2/html/emoticons/dry.gif) (IMG:http://www.914world.com/bbs2/html/emoticons/ohmy.gif)

WTF

After getting back in there I discovered the cable pulled out of the threaded piece that connects to the pedal linkage. WTF (IMG:http://www.914world.com/bbs2/html/emoticons/ohmy.gif)

So I have contacted PParts to see what they will do?? (IMG:http://www.914world.com/bbs2/html/emoticons/mad.gif)

I thought the $40 cable would hold up better then this..

[Kerrys914]

The Terry cable was thicker then the original one. Not by much.... but stll thicker.

I wonder if my pedal movment is not correct and causing this? The last 25% is tough but doesn't seem too bad.

The way I installed it was to open the carbs 100% and set the pedal to = this when fully depressed. I used the pedal board stop to keep from depressing too far. (IMG:http://www.914world.com/bbs2/html/emoticons/wink.gif)