 Sway bar install, where do the u-tabs go? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| robby750 |
 Feb 27 2006, 08:23 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 646 Joined: 6-April 03 From: Lexington, Ky Member No.: 521 Region Association: South East States  |
I am installing a stock front sway bar and have done everything but weld on the u-tabs. I have the drop links attached and set the tabs on the a-arms with the suspension unweighted on jack stands where they naturally line up with the ther end of the drop link. Is this the spot to tack them on?
|
   |
 
|
  |
Replies
| Mueller |
Feb 27 2006, 10:28 PM
Post
#2
|
||
|
914 Freak! Group: Members Posts: 17,146 Joined: 4-January 03 From: Antioch, CA Member No.: 87 Region Association: None 
|
either one.....fluxcore is normally messier and sometimes more difficult to get good penetration.......smack it with a hammer to make sure it doesn't fly off..... |
||
|
|
|
||
Posts in this topic
robby750 Sway bar install Feb 27 2006, 08:23 PM
bd1308 wait, you weld?
sorry for the hijack.
b Feb 27 2006, 08:24 PM robby750 My brother in law has a welder and is coming over ... Feb 27 2006, 08:28 PM Cloudbuster U-tab thread
Go to the last page for other ways o... Feb 27 2006, 08:30 PM Mueller ... Feb 27 2006, 08:35 PM rjames Should one weld these tabs using MIG, or fluxcore?... Feb 27 2006, 10:23 PM
Mueller if you want to pay for shipping, I'll send you... Feb 27 2006, 10:29 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 8th June 2024 - 02:41 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.