 SOT: 2-1/8" dia. holes in 0.5" AL manifold plates, Water jet? Vertical mill? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Gary |
 Mar 11 2006, 08:32 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 744 Joined: 12-January 03 From: Mount Airy, MD Member No.: 134 Region Association: MidAtlantic Region 
 |
Working on adapting a pair of Ninja 636 throttle bodies... They are on 75.6mm centers. There's a lip on the flange that will accomodate a 2" ID - 2 1/8" OD viton o-ring well. I have a couple 1/2" aluminum plates. Rather than going at them with a 2 1/8" hole saws, I figure the better solution is to see if someone has access to or can recommend a shop with a vertical mill or waterjet cutter.
Thnx! |
   |
 
|
  |
Replies
| Mueller |
Mar 13 2006, 01:10 PM
Post
#2
|
|
914 Freak! Group: Members Posts: 17,146 Joined: 4-January 03 From: Antioch, CA Member No.: 87 Region Association: None
|
I'm still debating whether to use an o-ring or just braze the throttle body to the plate.....my original idea of using the hose with clamp is not going to work as well as I thought it would due to interferance with the mounting hardware....
|
|
|
|
Posts in this topic
Gary SOT: 2-1/8" dia. holes in 0.5" AL manifold plates Mar 11 2006, 08:32 PM
Gary Bump...
I know some of you guys do your own fab a... Mar 12 2006, 06:50 PM r_towle yup, hole saw and some good cutting oil...keep it ... Mar 12 2006, 09:23 PM Aaron Cox laser cut? plasma? water jet? Mar 12 2006, 09:40 PM Brian Mifsud Depending on how hot you are to finish them, I... Mar 12 2006, 09:46 PM Gary Thanks Brian - may take you up that. My folks are ... Mar 12 2006, 11:12 PM Gary Eeuuwww... I would wonder/worry about warpage of t... Mar 13 2006, 07:30 PM Mueller Mar 14 2006, 12:09 AM
Porcharu I would use the 2" hole saw and finish them off wi... Mar 14 2006, 01:52 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 23rd May 2024 - 09:12 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.