 Temperature Sensor, Anyone know the resistance? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| billd |
 Mar 14 2006, 11:53 AM
Post
#1
|
|
Member  Group: Members Posts: 327 Joined: 25-May 05 From: Palo Alto, CA Member No.: 4,145  |
My temperature gauge always reads at the left extreme of the scale. While I'd like to think my engine is always running cool, I don't believe it.
I measured the sensor. It measures 2.3K ohms cold and 300 ohms hot. I checked the gauge. 300 ohms barely moves the needle. It takes a resistance of 50 ohms to get to full scale. Does anyone know what the correct resistance range is? I suspect I have the sensor for the aftermarket VDO gauge hooked up to a stock gauge. Pelican wants $30 for an OE senso while the aftermarket VDO sensors at $10 at Summit. Anyone know a less expensive solution? It would be cheaper to replace the gauge - the VDO gauge is $25 at Summit, but the 2.062 inch gauge won't fit into the 60mm hole (2.362 inch) in my center console. |
   |
 
|
  |
Replies
| lapuwali |
Mar 14 2006, 08:03 PM
Post
#2
|
|
Not another one! Group: Benefactors Posts: 4,526 Joined: 1-March 04 From: San Mateo, CA Member No.: 1,743  |
You can make a new front panel for the center console fairly easily, and redrill the holes to be any size you like.
You can also make a sleeve out of wood with a 60mm OD and a 52mm ID. You can send the gauge to PA Speedo to get it fixed and calibrated. |
|
|
|
Posts in this topic
billd Temperature Sensor Mar 14 2006, 11:53 AM
toon1 the Pennington book say's, 3k when cold, 1k wh... Mar 14 2006, 12:04 PM billd If this is true, then I suspect my gauge is bad - ... Mar 14 2006, 06:58 PM bd1308 maybe the guage sender wire is grounding out somew... Mar 14 2006, 08:13 PM billd egauges.com lists 10-180 ohms as the resistance ra... Mar 15 2006, 05:41 PM
BMartin914 You need to make sure that you get a sender that m... Mar 16 2006, 08:09 AM |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd June 2024 - 08:58 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.