 How tight to squeez the case, through bolts |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Al Meredith |
 Mar 17 2006, 08:02 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 960 Joined: 4-November 04 From: Atlanta, ga Member No.: 3,061  |
How tight should I torque the RACEWARE case through bolts?
|
   |
 
|
  |
Replies
| Cap'n Krusty |
Mar 17 2006, 09:03 PM
Post
#2
|
||
|
Cap'n Krusty Group: Members Posts: 10,794 Joined: 24-June 04 From: Santa Maria, CA Member No.: 2,246 Region Association: Central California |
Try 23.72 ft/lbs, NOT 40. You'll increase the bearing crush and increase the bearing wear dangerously. BAD MOVE! IMO, the torque spec remains 24 ft/lbs, Raceware, stock studs, or whatever. The Cap'n |
||
|
|
|
||
Posts in this topic
Al Meredith How tight to squeez the case Mar 17 2006, 08:02 PM
dimitri Porsche spec is 40 flbs, you will find even 2 mor... Mar 17 2006, 08:28 PM Jake Raby no more than 30 lb/ft....
The only way I go furth... Mar 17 2006, 09:03 PM Al Meredith Thanks to all 25/30 it is, Jake I'm assembling... Mar 18 2006, 07:45 AM Jake Raby I figured you were...
Have fun.. Mar 18 2006, 08:12 AM
dimitri I stand corrected, 25 it is. Should not have trust... Mar 18 2006, 11:58 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd June 2024 - 07:04 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.