 Engine out, One things leads to another |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| jfort |
 Apr 8 2006, 04:21 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,170 Joined: 5-May 03 From: Findlay, OH Member No.: 652 Region Association: Upper MidWest 
 |
Prior owner, Jim Chambers, had MSX gears for autocrossing. Car is quick, but it made it trying to be on the interstate. I decided to put the standard Z gear in for 5th. This work is being done by Tab Tanner at Autobahn Garage in Findlay Ohio. Here we are aligning the engine/jack fitting.
Attached image(s) 
|
   |
 
|
  |
Replies
| jfort |
Apr 8 2006, 04:29 PM
Post
#2
|
|
Senior Member Group: Members Posts: 1,170 Joined: 5-May 03 From: Findlay, OH Member No.: 652 Region Association: Upper MidWest
|
SOOOOO, as long as the engine is out, we get to looking at the rear suspension. terrible creaking noise and the right rear tire is out about an inch more than the left one. can see where the car was hit and it bent the rear suspension. measurements confirm. So, it is going to a place that has a frame rack and computer. They say they can get it back to within a millemeter or two.
Attached image(s) 
|
|
|
|
Posts in this topic
jfort Engine out Apr 8 2006, 04:21 PM
jfort got the engine out in less than an hour and separa... Apr 8 2006, 04:22 PM jfort I didn't think we'd get it back together. Apr 8 2006, 04:24 PM jfort we changed one of the shifting forks, too, as one ... Apr 8 2006, 04:25 PM jfort I was surprised that they immediately called up th... Apr 8 2006, 04:31 PM Porsche Rescue Good to see the car again Jeff. I have had several... Apr 8 2006, 05:16 PM jetboy Apr 9 2006, 12:17 AM ! I just did a trans and engine tear down on my tail... Apr 9 2006, 12:24 AM jfort it is at a normal body/frame shop. they use a com... Apr 9 2006, 05:44 PM
rhodyguy this is very interesting. are the unibody correcti... Apr 9 2006, 05:48 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 12:17 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.