 Welding on rear fenders, any tips? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| proto31 |
 Apr 7 2006, 11:58 PM
Post
#1
|
|
Member  Group: Members Posts: 413 Joined: 2-February 06 From: Costa Mesa, CA. Member No.: 5,515 Region Association: None   |
I'm getting my project car in about two weeks and will need to weld on the rear fenders before I can begin any body work. Anyone have any good suggestions on welding on rear fenders. Any tips on what type of welder to use. I use to use a mig welder. Unfortunetly I do not have a welder and will have to rent one.
|
   |
 
|
  |
Replies
| proto31 |
Apr 9 2006, 11:49 PM
Post
#2
|
|
Member Group: Members Posts: 413 Joined: 2-February 06 From: Costa Mesa, CA. Member No.: 5,515 Region Association: None |
Thanks for all the advice. (IMG:http://www.914world.com/bbs2/html/emoticons/pray.gif) Joe, I was going to call you sometime this week. I have a billion other questions to ask. Yes, I took the bar. Didn't get my results yet. The car comes in less then 2 weeks. Any suggestions on what I should build/buy as a devise to put the tub on. It will come with no suspension installed... Joe, could I get your phone number again?
Thanks |
|
|
|
Posts in this topic
proto31 Welding on rear fenders Apr 7 2006, 11:58 PM
Krieger914 http://www.914world.com/bbs2/ht... Apr 8 2006, 12:04 AM Mueller advice on the welder.....use one that has gas, flu... Apr 8 2006, 12:11 AM proto31 I'm replacing the entire rear fender on both s... Apr 8 2006, 12:16 AM Aaron Cox you may be better off paying a pro if ya gotta ask... Apr 8 2006, 12:19 AM Mueller Apr 8 2006, 12:41 AM Andyrew Welding local to me was 50 per day, 100 per week a... Apr 8 2006, 04:36 AM JPB All ya need is a buzz box and a scratch start tig ... Apr 8 2006, 06:06 AM riverman Since you'll be welding sheet metal, you shoul... Apr 8 2006, 06:52 AM Joe Sharp Come by the house and try my welder to see if you ... Apr 8 2006, 07:38 AM
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 30th December 2025 - 03:05 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.