 Help please, with rear trailing arm hub |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| bodyman |
 Jun 10 2006, 06:58 PM
Post
#1
|
|
Michael Beall  Group: Members Posts: 63 Joined: 25-April 06 From: Sand Springs, Oklahoma Member No.: 5,926  |
Ok, I have the rear trailing arm off to replace it. I need to change the hub frm mine to the replacement one, But I have no idea how to get them off.... I see the screws but I can not get to the. Whats the trick?
(IMG:http://i5.tinypic.com/140f4zt.jpg) (IMG:http://i5.tinypic.com/140f57r.jpg) Thanks again guys.... Michael |
   |
 
|
  |
Replies
| davep |
Jun 10 2006, 07:36 PM
Post
#2
|
|
914 Historian Group: Benefactors Posts: 5,159 Joined: 13-October 03 From: Burford, ON, N0E 1A0 Member No.: 1,244 Region Association: Canada  |
I have often used a wooden drift to knock the hub out of the bearing. The plate with bolts you see retains the bearing. Or at least the outer race of the bearing since often part of the inner race comes out with the hub. Basically you should always replace the wheel bearing when changing hubs. There is little chance of it not being damaged.
|
|
|
|
Posts in this topic
bodyman Help please, with rear trailing arm hub Jun 10 2006, 06:58 PM
d914 BFH, or bearing puller
look up older thread, lots... Jun 10 2006, 07:04 PM Gary Check this thread. Do you really need to replace t... Jun 10 2006, 07:23 PM Eric_Shea Factory Manual says "suitable drift" whi... Jun 10 2006, 08:50 PM bodyman well unfortunantly I have to change the bearings i... Jun 10 2006, 10:03 PM
Eric_Shea While it is a good idea to replace the bearings wh... Jun 11 2006, 11:01 AM |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 17th June 2024 - 09:27 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.