 Help please, with rear trailing arm hub |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| bodyman |
 Jun 10 2006, 06:58 PM
Post
#1
|
|
Michael Beall  Group: Members Posts: 63 Joined: 25-April 06 From: Sand Springs, Oklahoma Member No.: 5,926  |
Ok, I have the rear trailing arm off to replace it. I need to change the hub frm mine to the replacement one, But I have no idea how to get them off.... I see the screws but I can not get to the. Whats the trick?
(IMG:http://i5.tinypic.com/140f4zt.jpg) (IMG:http://i5.tinypic.com/140f57r.jpg) Thanks again guys.... Michael |
   |
 
|
  |
Replies
| bodyman |
Jun 10 2006, 10:03 PM
Post
#2
|
|
Michael Beall Group: Members Posts: 63 Joined: 25-April 06 From: Sand Springs, Oklahoma Member No.: 5,926 |
well unfortunantly I have to change the bearings in the replacement trailing arm. I pulled it from my parts car and before I removed the wheel I checked to see if therewas any play, and the hub wiggled back and forth. My hub was good on my car but the trailing arm was bent. I do have another parts car, But It has been sitting several years so Im sure the bearings would need replaced as well. So is there any retainer clips I need to remove before I commence to pounding it out...lol There is a porsche shop that has a lot of 914s here in town, So would it be better to pay them to do it? Id rather save the money and do it myself if possible.
|
|
|
|
Posts in this topic
bodyman Help please, with rear trailing arm hub Jun 10 2006, 06:58 PM
d914 BFH, or bearing puller
look up older thread, lots... Jun 10 2006, 07:04 PM Gary Check this thread. Do you really need to replace t... Jun 10 2006, 07:23 PM davep I have often used a wooden drift to knock the hub ... Jun 10 2006, 07:36 PM Eric_Shea Factory Manual says "suitable drift" whi... Jun 10 2006, 08:50 PM
Eric_Shea While it is a good idea to replace the bearings wh... Jun 11 2006, 11:01 AM |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 17th June 2024 - 09:33 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.