Home  |  Forums  |  914 Info  |  Blogs
 
914World.com - The fastest growing online 914 community!
 
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG. This site is not affiliated with Porsche in any way.
Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners.
 

Welcome Guest ( Log In | Register )

> Installation of Innovate LC-1
lmcchesney
post Jul 28 2006, 02:40 PM
Post #1


Member
**

Group: Members
Posts: 488
Joined: 24-November 03
From: Ocala, Fl.
Member No.: 1,381
Region Association: None
I'm installing the LC-1. I got the bung welded on the exhaust pipe just after the 4:1 connection on the Bursch exhaust pipe at about 10-20degrees off top center line. The cord does not make it to the engine tin between the tranny and engine. The big connector will have to sit on top of the tranny and the cord running through the engine tin with a grommet. From there, it runs along the top of the engine and down the firewall and into the cabin along side the main wire harness of the engine/cabin. Is this acceptable?
Larry
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
 
 Reply to this topicStart new topic
Replies
lmcchesney
post Jul 28 2006, 05:13 PM
Post #2


Member
**

Group: Members
Posts: 488
Joined: 24-November 03
From: Ocala, Fl.
Member No.: 1,381
Region Association: None
I believe the controler is the rectangular box which the sensor cable connects to and has the 7 wires and 2 serial cables leaving it. I was planning on the controller to run allong the tranny. Is this OK?
Larry
User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Posts in this topic
lmcchesney   Installation of Innovate LC-1   Jul 28 2006, 02:40 PM
lapuwali   Is the sensor cable to the controller long enough ...   Jul 28 2006, 02:57 PM
DNHunt   I have a TechEdge WBO2 sensor and I ran the cable ...   Jul 28 2006, 04:18 PM
lmcchesney   I believe the controler is the rectangular box whi...   Jul 28 2006, 05:13 PM
Mueller  
 

Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 

- Lo-Fi Version Time is now: 1st August 2025 - 08:28 AM
Invision Power Board v9.1.4 © 2025  IPS, Inc.
All rights reserved 914World.com © since 2002
914World.com is the fastest growing online 914 community!
We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ...