 I need info/help on how to generate an advance curve with MAP, Going all in! |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Dr Evil |
 Jul 28 2006, 10:00 PM
Post
#1
|
|
Send me your transmission!  Group: Members Posts: 23,038 Joined: 21-November 03 From: Loveland, OH 45140 Member No.: 1,372 Region Association: MidAtlantic Region 
 |
I have a few advance curves to consider for my distributorless ignition system, but all of them are for the mechanical aspect only without consideration for manifold air pressure (vacuum).
Where do I find a chart or info on MAP affect on the advance? If no chart/data, how do I generate such a set of data points? Which advance curve should I use for a 2.7 with SC cams? The following is all I have to go off of: Attached image(s)   
|
   |
 
|
  |
Replies
| Dr Evil |
Jul 29 2006, 01:20 PM
Post
#2
|
|
Send me your transmission! Group: Members Posts: 23,038 Joined: 21-November 03 From: Loveland, OH 45140 Member No.: 1,372 Region Association: MidAtlantic Region
|
It is possibel that I did ask this or a similar question, but I assure you that I was not as clear as I needed to be. For the next 2 weeks I can wrap my head around this problem where as before I had med school stuff to contend with and that makes one forget much of what they knew. I am hoping to make this thread as direct and action packed as possible. I have posted what I have so far, which is arguably incomplete.
I know I was asking about timing, but I did not know enough about the MJLJ programming to ask questions correctly (getting better, I hope). |
|
|
|
Posts in this topic
Dr Evil I need info/help on how to generate an advance curve with MAP Jul 28 2006, 10:00 PM
DNHunt I'm not sure how much this will help you but, ... Jul 29 2006, 08:59 AM DNHunt This is a quess. Consider it a mental exercise and... Jul 29 2006, 10:27 AM Dr Evil Hey Dave, thanks for the info. I am heading out of... Jul 29 2006, 12:54 PM TimT Didnt you just ask this question a few weeks ago? ... Jul 29 2006, 01:17 PM fiid There is an excellent thread on this topic on the ... Jul 29 2006, 03:36 PM
Dr Evil Dave and Fiid,
the info you guys posted is spot on... Jul 31 2006, 09:11 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 11th May 2025 - 09:13 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.