 Harness Bar for a 1970 Mod. |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| yeti |
 Oct 6 2006, 09:50 AM
Post
#1
|
|
Newbie  Group: Members Posts: 34 Joined: 4-May 06 From: Germany Member No.: 5,974  |
Hello,
just have a short question. Will a harness bar like this http://www.914world.com/bbs2/index.php?show...;hl=Harness+bar fit in a 914 with fixed passenger side? Thanks and have a good time. Yeti |
   |
 
|
  |
Replies
| Aaron Cox |
Oct 6 2006, 04:23 PM
Post
#2
|
|
Professional Lawn Dart Group: Retired Admin Posts: 24,541 Joined: 1-February 03 From: OC Member No.: 219 Region Association: Southern California |
also....
when you drill the holes inthe firewall... you need to use the big washers.. AND they need to be mounted to bare metal.... not thru a soundpad etc.... designed for ZERO compliance..... metal to metal on both sides... cut soundpat/and backpad to fit OVER THEM... not sandwiched by them |
|
|
|
Posts in this topic
yeti Harness Bar for a 1970 Mod. Oct 6 2006, 09:50 AM
mikez Fit? Yes.....but the backpad will need some mods. Oct 6 2006, 10:02 AM yeti Hello,
are some picture available? Do I have to cu... Oct 6 2006, 10:14 AM Aaron Cox PM joe sharp...
he has a custom harnes bar that g... Oct 6 2006, 10:36 AM Brad Roberts Please read your competition seat belt install boo... Oct 6 2006, 12:07 PM spunone So Brad you saying you need to have the harness ba... Oct 6 2006, 01:58 PM Aaron Cox below = spine compression in crash
i think you wan... Oct 6 2006, 01:59 PM spunone And if your spineless? :rotfl: 15degree up ?shoul... Oct 6 2006, 02:02 PM Aaron Cox 0 degrees - level with your shoulder...
15 degrees... Oct 6 2006, 02:13 PM yeti Hi, I know about the problem with the shoulder str... Oct 6 2006, 03:31 PM Brad Roberts Drill holes for eye bolts in the firewall just bel... Oct 6 2006, 03:39 PM
spunone Thanks fellas now I get it Oct 6 2006, 04:36 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd June 2024 - 10:59 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.