Home  |  Forums  |  914 Info  |  Blogs
 
914World.com - The fastest growing online 914 community!
 
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG. This site is not affiliated with Porsche in any way.
Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners.
 

Welcome Guest ( Log In | Register )

> 914/6 dies with hard braking
rudedude
post Nov 6 2006, 09:32 AM
Post #1


Senior Member
***

Group: Members
Posts: 521
Joined: 1-January 05
From: minneapolis, mn
Member No.: 3,387
Region Association: Upper MidWest



I had to dynamite the brakes to save myself, or my car, the other day and the engine died. It easily restarted, air temp was 40 degrees or so, then I hit the brakes again with the same response. I thought maybe its happening due to temp but it was 60 yesterday and the same thing happened. It had never happened before tha first incident and I'm perplexed as to why it is now happening. It otherwise runs great and I hanen't done anything recently that should cause this to happen.
Any ideas?
thanks, jule
User is online!Profile CardPM
Go to the top of the page
+Quote Post
 
Reply to this topicStart new topic
Replies
jsteele22
post Nov 6 2006, 05:21 PM
Post #2


Senior Member
***

Group: Members
Posts: 727
Joined: 24-August 05
From: Colorado Springs, CO
Member No.: 4,653



Well, if it idles without cutting out, you've got a leg up. Start the engine, pop the engine lid, and grab hold of each wire, hose, vacuum line, etc. one by one and wiggle them. Especially old connectors, grab each wire individually and push/pull. Make sure each one is okay before moving on to the next. I found two major faults this way. One was a fuel line that was old, and partly folded. Enough fuel got through to idle smoothly, but at higher RPM/load, it would starve, engine would buck, unkinking the hose, engine would rev, starve, etc. I just noticed that when I wiggled the fuel line (which didn't look all that bad) it made the engine stumble. The other was one of the lines into the pressure sensor connector. When the connector was pushed onto its mate, one line would slip out just a tiny bit. If it slipped far enough, it was a total no-start/no-run situation. Every car is different, so check everything.
User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



- Lo-Fi Version Time is now: 4th July 2025 - 11:22 AM