 Can the trunk lids be adjusted at the latches? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Mid_Engine_914 |
 Nov 18 2006, 02:41 PM
Post
#1
|
|
Member  Group: Members Posts: 195 Joined: 22-September 06 From: Left Coast Member No.: 6,888  |
Both my front and rear trunk lids don't fit flush with the fenders (they sit about a 1/4 in. high) so I was wondering how can I adjust them so they fit as good as on Trevorg7's car?
(IMG:http://www.914world.com/bbs2/uploads/post-3241-1163556748.jpg) (IMG:http://www.914world.com/bbs2/uploads/post-3241-1163556839.jpg) |
   |
 
|
  |
Replies
| abearauto |
Nov 18 2006, 09:07 PM
Post
#2
|
|
Newbie Group: Members Posts: 45 Joined: 10-May 03 From: washougal wa. Member No.: 677 |
if the old trunk seals are oem , putting new ones on wont fix the problem, will make it worse untill they seat in, the old ones in good conditoion will allow the trunk to set down farther, is the rear trunk seal in the correct way not backwards? i found one that was installed backwards, the seal is designed to kinda fold over and seal , took me awhile to figure that one out trying to adust the deck lid with a rear seal removed from another car , who the p/o must have put in on backwards, and it had been seated wrong,, just my 2cents good luck
|
|
|
|
Posts in this topic
Mid_Engine_914 Can the trunk lids be adjusted at the latches? Nov 18 2006, 02:41 PM
Chogokin I have the same problem, I was thinking about putt... Nov 18 2006, 02:44 PM abearauto if you can supply any photos here then i can walk ... Nov 18 2006, 05:55 PM 914Sixer Do not forget to adjust the rubber stopper in each... Nov 18 2006, 06:49 PM Jeff Bowlsby The rear trunk male part on the lid has a big nut ... Nov 18 2006, 06:55 PM Mid_Engine_914 Thanks for the advice. I adjusted the front trunk ... Nov 18 2006, 08:04 PM
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 31st May 2024 - 05:42 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.