 Start-up an engine out of the car, Tips & Tricks? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| computers4kids |
 Dec 26 2006, 11:09 PM
Post
#1
|
|
Love these little cars!  Group: Members Posts: 2,443 Joined: 11-June 05 From: Port Townsend, WA Member No.: 4,253 Region Association: None  |
I have a couple of complete 2.0 motors in my garage that I would like start-up in my garage but out of the car. I can do a leak down test on both of them and do a compression test, but I would also like to see how the run, adjust valves, timing, before I install one of them. They are both FI motors.
Any tips or advice? Attached image(s) 
|
   |
 
|
  |
Replies
| newto914s |
Dec 27 2006, 10:41 AM
Post
#2
|
|
Senior Member Group: Members Posts: 561 Joined: 16-February 04 From: Thornton, CO Member No.: 1,663 |
I think his question was more along the lines of "how would you wire it up to run a FI car out side the car." And if I'm wrong in my assumtion then that's my question. Carbed cars are easy to hot wire; 12volts to ignition,gravity feed the carbs, crank, and vroom.
|
|
|
|
Posts in this topic
computers4kids Start-up an engine out of the car Dec 26 2006, 11:09 PM
sww914 Secure it to the ground so it won't torque it... Dec 27 2006, 01:08 AM
computers4kids
You should go with the one with the best leakdown... Dec 27 2006, 12:41 PM Twystd1 If the engine has been sitting around for a long t... Dec 27 2006, 01:52 AM Paul Illick A stand is best. If you start it on the floor I... Dec 27 2006, 04:58 AM ptravnic I believe that in order to use the FI out of the c... Dec 27 2006, 05:06 AM thesey914 I've run my motor on the floor. It was on a pi... Dec 27 2006, 09:53 AM computers4kids
I believe that in order to use the FI out of the ... Dec 27 2006, 12:53 PM Twystd1 DO NOT put the engine on a piece of carpet to ligh... Dec 27 2006, 02:40 PM Lawrence I've never felt comfortable seeing a 914 engin... Dec 27 2006, 03:23 PM machina its easy, just stand back till she clears the towe... Dec 27 2006, 04:29 PM machina OK, this is probably not the best way to do it but... Dec 27 2006, 04:56 PM ptravnic Funny stuff. That was Leo Imperial's engine i... Dec 27 2006, 05:54 PM scotty b Not the best footage (shot at night) but exhaust s... Dec 27 2006, 06:31 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 15th June 2024 - 11:49 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.