 CV joint dis-assembly, re-assembly..pictures enclosed, please add info or critic the instructions :) |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Mueller |
 Jan 14 2007, 01:17 AM
Post
#1
|
|
914 Freak!  Group: Members Posts: 17,146 Joined: 4-January 03 From: Antioch, CA Member No.: 87 Region Association: None 
 |
follow the red spots..pay attention to the how the "point" goes to the "wide" section of the mating part.
starting at the top picture, if both hands are on the CV at the 9 and 3 o'clock postion, your fingers on your left hand would be pushing "up" while your thumb on the right hand would be pushing down. When the middle section is about 90° to it's original postion, it will slide right out (with a little help, but not much) reassembly is reverse...  |
   |
 
|
  |
Replies
| So.Cal.914 |
Jan 14 2007, 01:23 AM
Post
#2
|
|
"...And it has a front trunk too." Group: Members Posts: 6,588 Joined: 15-February 04 From: Low Desert, CA./ Hills of N.J. Member No.: 1,658 Region Association: None |
Very Cool, Thanks. It's one for my '914 maintainance info' folder
|
|
|
|
Posts in this topic
Mueller CV joint dis-assembly, re-assembly..pictures enclosed Jan 14 2007, 01:17 AM
swood Thanks again.
Is there an assembly of the drives... Jan 14 2007, 01:30 AM Aaron Cox MIKE...
thanks for taking the time to do the step... Jan 14 2007, 01:31 AM
Mueller
MIKE...
thanks for taking the time to do the ste... Jan 14 2007, 01:39 AM neo914-6 Hey Mike,
How did you clean the grease off them? Jan 14 2007, 01:44 AM swood They was new. Jan 14 2007, 01:47 AM McMark Thanks Mike! Good stuff!
I'll just b... Jan 14 2007, 02:44 AM Headrage Hey Mike, check your PM's... :D Jan 14 2007, 09:43 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 17th June 2024 - 01:48 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.