follow the red spots..pay attention to the how the "point" goes to the "wide" section of the mating part.

starting at the top picture, if both hands are on the CV at the 9 and 3 o'clock postion, your fingers on your left hand would be pushing "up" while your thumb on the right hand would be pushing down.

When the middle section is about 90° to it's original postion, it will slide right out (with a little help, but not much)

reassembly is reverse...


Click to view attachment

Very Cool, Thanks. It's one for my '914 maintainance info' folder

Thanks again.


Is there an assembly of the driveshaft thread anywhere? I've started a "how to not..." thread on my own. I know it's simple, but I've never done it before.

MIKE...

thanks for taking the time to do the step by step pics... your an asset to the community
AA

Hey Mike,

How did you clean the grease off them?

They was new.

Thanks Mike! Good stuff!

I'll just buy mine already done.

Hey Mike, check your PM's...