 Height required to remove 6 cyl. |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| xsurfer |
 Jan 28 2007, 08:29 PM
Post
#1
|
|
Member  Group: Members Posts: 279 Joined: 4-April 06 From: La Canada, CA Member No.: 5,818  |
I'm a new 914-6 owner. I need to drop the engine but don't know the height required to get the engine and trans out. Anybody know if ramps are ok vs. axle stands?
|
   |
 
|
  |
Replies
| Jeffs9146 |
Jan 28 2007, 08:38 PM
Post
#2
|
|
Ski Bum Group: Members Posts: 4,062 Joined: 10-January 03 From: Discovery Bay, Ca Member No.: 128 |
It depends on the motor and the jack you are using! See the attached photo! I couldn't lower the motor very far with this type of jack so I had to raise the car.
Jeff Attached image(s) 
|
|
|
|
Posts in this topic
xsurfer Height required to remove 6 cyl. Jan 28 2007, 08:29 PM
dflesburg Good Grief man,
Bad jack! Bad! Bad! Jan 28 2007, 08:51 PM mikez Not too tall, Clay can do it..... Jan 28 2007, 08:59 PM Jeffs9146
:agree: I had to do it like that because I was ... Jan 28 2007, 09:15 PM mikez Why did you pull the swing arms? Jan 28 2007, 09:31 PM jimkelly can't you just use a furniture dolly and lower... Jan 28 2007, 09:34 PM
So.Cal.914
can't you just use a furniture dolly and lowe... Jan 28 2007, 09:59 PM Jeffs9146
One was bent so I took everything off, replaced ... Jan 28 2007, 09:35 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 11th May 2025 - 01:34 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.