 how do i change shift linkage bushings?, tail shift(pre 73) |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| shaggy |
 Jan 28 2007, 11:16 PM
Post
#1
|
|
mechanic/welder/fabricator  Group: Members Posts: 702 Joined: 26-September 05 From: Gilbert, AZ Member No.: 4,869 Region Association: None  |
how do i change the shift bushings in/on the shift rod from my 72?
i have the back half of the rod removed and do not see any of the bushings. how do i remove the front half? and how do i change the balls and the ball socket on the bottom of the shifter? -jim |
   |
 
|
  |
Replies
| So.Cal.914 |
Jan 28 2007, 11:48 PM
Post
#2
|
|
"...And it has a front trunk too." Group: Members Posts: 6,588 Joined: 15-February 04 From: Low Desert, CA./ Hills of N.J. Member No.: 1,658 Region Association: None |
QUOTE(shaggy @ Jan 28 2007, 09:16 PM)  how do i change the shift bushings in/on the shift rod from my 72 i have the back half of the rod removed and do not see any of the bushings. On the end of the trans by the tail shift rod is a bracket that bolts on, your shift rod passes thru it right at the rear of the car, one goes there. QUOTE how do i remove the front half? I don't think I did to replace it, I think I just worked it around that 90 degree pivot off and on. QUOTE and how do i change the balls and the ball socket on the bottom of the shifter? -jim The nylon socket just pops off of the ball at the end of the shifter. I removed the ball on the shifter to put on a quick shift kit, I used mapp gas to heat it up and it tapped off. You will epoxy the new one on. |
|
|
|
Posts in this topic
shaggy how do i change shift linkage bushings? Jan 28 2007, 11:16 PM
Scott-thundercat so that's why my shifter has slop- it has no b... Jan 28 2007, 11:52 PM
shaggy epoxy like jb weld or what?
so you used MAPP to h... Jan 28 2007, 11:58 PM So.Cal.914
epoxy like jb weld or what?
so you used MAPP to ... Jan 29 2007, 01:39 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 16th June 2024 - 05:10 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.