 end play, installing flywheel |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| 41ghost |
 Feb 18 2007, 10:21 AM
Post
#1
|
|
Member  Group: Members Posts: 235 Joined: 13-July 04 From: noblesville,in. Member No.: 2,345  |
when installing a flywheel you are suppose to check for how much endplay there is. how do you adjust the endplay after you measure it? or do you just get whatever it is.
|
   |
 
|
  |
Replies
| Aaron Cox |
Feb 18 2007, 11:34 AM
Post
#2
|
|
Professional Lawn Dart Group: Retired Admin Posts: 24,542 Joined: 1-February 03 From: Corona, CA Member No.: 219 Region Association: Southern California |
why is it 3 shims though?
if you can get .005 with 2 shims, why not? i know the answer is 3 shims, just curious why... |
|
|
|
Posts in this topic
41ghost end play Feb 18 2007, 10:21 AM
craig downs You use a combination of three flywheel shims to g... Feb 18 2007, 10:31 AM 41ghost where do these shims go ? Feb 18 2007, 10:37 AM Headrage
where do these shims go ?
Between the flywheel ... Feb 18 2007, 10:58 AM Borderline I believe the spec is .004", however in Jake... Feb 18 2007, 11:07 AM Dave_Darling You put the flywheel on with a couple of shims, th... Feb 18 2007, 11:11 AM 41ghost if you are already at .044 how do you get to .005 ... Feb 18 2007, 11:36 AM
Bleyseng You must do the measuring without the rear seal in... Feb 18 2007, 12:21 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 4th July 2025 - 12:10 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.