 Engine and Transmission mounts, for a 76. |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| blitZ |
 Mar 13 2007, 07:21 AM
Post
#1
|
|
Beer please...  Group: Members Posts: 2,223 Joined: 31-August 05 From: Lawrenceville, GA Member No.: 4,719 Region Association: South East States  |
My engine and transmission mounts have no rubber pieces, like I have read they should have. I'm going to get new mounts. I assume the rubber donut for the engine mount goes on top, above the mounting plate? I
The transmission mount is the same way, no rubber damper at all. I'm thinking of using JWest hard nylon mounts for the engine and the solid mounts from PP for the transmission, anyone else use these? Thanks |
   |
 
|
  |
Replies
| BAM |
Mar 13 2007, 09:46 AM
Post
#2
|
|
Don’t sweat the small stuff !!! Group: Members Posts: 69 Joined: 10-January 07 From: SF Bay Area Member No.: 7,442 |
QUOTE(blitZ @ Mar 13 2007, 06:21 AM)  My engine and transmission mounts have no rubber pieces, like I have read they should have. I'm going to get new mounts. I assume the rubber donut for the engine mount goes on top, above the mounting plate? I The transmission mount is the same way, no rubber damper at all. I'm thinking of using JWest hard nylon mounts for the engine and the solid mounts from PP for the transmission, anyone else use these? Thanks Hi blitZ, I have sold and installed the JWest nylon mounts and have had nothing but good feedback… Regarding the Trans mounts, personally I am not a big fan of the solid mounts. I like to install 911 sport engine mounts and used them as 914 transmission mounts, also nothing but good feedback. Hope this helps. JP |
|
|
|
Posts in this topic
blitZ Engine and Transmission mounts Mar 13 2007, 07:21 AM
blitZ I was looking at the 911 sport mounts also. Are t... Mar 13 2007, 10:02 AM rhodyguy if i read this correctly...for your 76', the e... Mar 13 2007, 10:16 AM
Bleyseng The engine bar is bolted without any rubber at the... Mar 13 2007, 10:19 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd June 2024 - 06:23 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.