 cold start valve |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| sk8kat1 |
 Mar 21 2007, 11:01 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 911 Joined: 10-October 05 From: belvidere ,IL Member No.: 4,937  |
ok I am installing a replacement engine and going over the engine before I plop her in the teener and low an behold the fuel line to the cold start valve has been cut and I can't find an open spot for the line to go to ?! please help ...2.0L d jet
|
   |
 
|
  |
Replies
| sk8kat1 |
Mar 21 2007, 12:27 PM
Post
#2
|
|
Senior Member Group: Members Posts: 911 Joined: 10-October 05 From: belvidere ,IL Member No.: 4,937 |
so will the engine will still run properly even witk out the cold start valve .. except at first start ... right?!
|
|
|
|
| Rand |
Mar 21 2007, 12:42 PM
Post
#3
|
|
Cross Member Group: Members Posts: 7,413 Joined: 8-February 05 From: OR Member No.: 3,573 Region Association: None |
QUOTE(sk8kat1 @ Mar 21 2007, 10:27 AM)  so will the engine will still run properly even witk out the cold start valve .. except at first start ... right?! Yes. And even first start. It doesn't do anything at all unless it's truly cold (below 40 anyway). I don't have a CSV any more and my car starts fine at freezing temps. |
|
|
|
Posts in this topic
sk8kat1 cold start valve Mar 21 2007, 11:01 AM
Bleyseng look at this pic Mar 21 2007, 11:10 AM
sk8kat1
look at this pic
I can't tell where it lea... Mar 21 2007, 11:16 AM Bleyseng The side with the FP has the rail with three outle... Mar 21 2007, 11:31 AM sk8kat1
The side with the FP has the rail with three outl... Mar 21 2007, 11:53 AM Bleyseng If one has the screw in it, take it out and run th... Mar 21 2007, 11:54 AM sk8kat1 fuel pressure reg side.. Mar 21 2007, 11:56 AM jasons They are the same. Which ever one you use on the ... Mar 21 2007, 11:56 AM sk8kat1 well ok then... :D Mar 21 2007, 11:57 AM sk8kat1 sweet!!! :thumbsup: Mar 21 2007, 01:02 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st August 2025 - 12:47 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.