 How do you know if a pressure plate is still good?, Picture attached |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Justinp71 |
 Mar 28 2007, 08:00 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,583 Joined: 11-October 04 From: Sacramento, CA Member No.: 2,922 Region Association: None 
 |
Here is the pic of my pressure plate, it has alot of spotting but it seemed to work fine in the car and its not blue.
I am putting in a new clutch (also machining flywheel), should I replaced the pressure plate at a hefty $160? It seems like it may be a waste of money. Attached thumbnail(s) 
|
   |
 
|
  |
Replies
| John |
Mar 28 2007, 08:59 PM
Post
#2
|
|
member? what's a member? Group: Members Posts: 3,393 Joined: 30-January 04 From: Evansville, IN (SIRPCA) Member No.: 1,615 Region Association: None |
If you have the flywheel machined, be damn sure that it gets balanced as well, or you will be pulling it back out. (I had that happen once)
|
|
|
|
Posts in this topic
Justinp71 How do you know if a pressure plate is still good? Mar 28 2007, 08:00 PM
Cap'n Krusty You're not "putting in a new clutch... Mar 28 2007, 08:05 PM
Justinp71
You're not "putting in a new clutch... Mar 28 2007, 08:10 PM LowGT That surface looks horrible. I'd junk it. Mar 28 2007, 08:14 PM Martin Baker DAMN Justin...you said it didn't look that bad... Mar 28 2007, 08:17 PM Joe Ricard Also check the run out on the flywheel
no sense p... Mar 28 2007, 08:19 PM Justinp71
Also check the run out on the flywheel
no sense ... Mar 28 2007, 08:50 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st June 2024 - 02:06 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.