Home  |  Forums  |  914 Info  |  Blogs
 
914World.com - The fastest growing online 914 community!
 
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG. This site is not affiliated with Porsche in any way.
Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners.
 

Welcome Guest ( Log In | Register )

> horn button wiring, momo hub and steering wheel
will
post Apr 11 2007, 10:20 PM
Post #1


licensed to kill
**

Group: Members
Posts: 272
Joined: 14-December 05
From: rancho cucamonga, california
Member No.: 5,276



how do you hook up the wire for the horn button on a momo hub and steering wheel?
thanks,
will
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
 
Reply to this topicStart new topic
Replies
srthompson01
post Apr 11 2007, 11:10 PM
Post #2


Newbie
*

Group: Members
Posts: 45
Joined: 24-September 06
From: oklahoma
Member No.: 6,906



Take the great big washer under the nut that holds steering wheel on, drll a very small hole as close as possible to the outer edge of the washer.

Get a spade connector and put on ground wire of horn button, the other side of the connector to a 4 inch ling piece of wire, strip an inch of insulation off of the other end of the wire and push though newly drilled hole an twist together to hold.

Take the push connector off of old horn button, connect to red wire on momo with a spade connector.

Turn on key and honk horn.

If it works, disconnect using spades, install mounting hub, tighten bolt over drilled washer, put on the steering wheel, connect horn button, and then bolt it down. If you don't have light hold loctite you can put a little fingernail polish on the threads.

Stephen
User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



- Lo-Fi Version Time is now: 10th June 2024 - 12:15 PM