 removing window tint, how? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| TheCabinetmaker |
 Apr 15 2007, 10:48 AM
Post
#1
|
|
I drive my car everyday  Group: Members Posts: 8,304 Joined: 8-May 03 From: Tulsa, Ok. Member No.: 666  |
Friend just bought a 86 carrera targa. the rear window is tinted. How can you remove the tint without damaging the defogger wiring? I know from personal experience that lacquer thinner and such will not touch the glue.
Thanks, Curt |
   |
 
|
  |
Replies
| So.Cal.914 |
Apr 15 2007, 11:47 AM
Post
#2
|
|
"...And it has a front trunk too." Group: Members Posts: 6,588 Joined: 15-February 04 From: Low Desert, CA./ Hills of N.J. Member No.: 1,658 Region Association: None |
Thats why you are holding the razor at such an extreme angle and with a light
touch. It gives you more of the film to cut into, and only the film. Make sure you keep it moist. Start your cut at the top where there are no wires and deep enough there to be able to lift the film with the razor after the cuts are done. |
 |
|
Posts in this topic
vsg914 removing window tint Apr 15 2007, 10:48 AM
So.Cal.914 I can tell you one way, Add a small amount of soap... Apr 15 2007, 11:23 AM vsg914 Won't that damage the defroster wiring? Apr 15 2007, 11:36 AM jasons Easiest way, and I learned this from a tint pro. ... Apr 15 2007, 01:01 PM
So.Cal.914
Easiest way, and I learned this from a tint pro. ... Apr 15 2007, 05:14 PM Matt Romanowski The amonia mix works better, but you can just use ... Apr 15 2007, 07:16 PM Jenny Ditto on the ammonia mixture. Works really well. ... Apr 16 2007, 11:43 AM effutuo101 I live in the NW where sun is limited and the Heat... Apr 16 2007, 11:47 AM jasons
I live in the NW where sun is limited and the Hea... Apr 16 2007, 12:07 PM Jeffs9146 Take the window out and soak it in the above menti... Apr 16 2007, 05:30 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 10th June 2024 - 10:11 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.