 Cone Screws |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| StratPlayer |
 Apr 17 2007, 08:13 PM
Post
#1
|
|
StratPlayer  Group: Members Posts: 3,278 Joined: 27-December 02 From: SLC, Utah Member No.: 27 Region Association: Rocky Mountains 
 |
Any tips or tricks to getting the screws loose without stripping them out. Bastards won't budge.
|
   |
 
|
  |
Replies
| Dave_Darling |
Apr 17 2007, 11:26 PM
Post
#2
|
|
914 Idiot Group: Members Posts: 14,991 Joined: 9-January 03 From: Silicon Valley / Kailua-Kona Member No.: 121 Region Association: Northern California
|
Agreed. Don't use one of those "wobble" or ball-end Allen bits, they don't grab the hex as well. Tap it in there with a hammer (not too hard!) to make sure it's fully seated. Then apply some grunt to it.
--DD |
|
|
|
Posts in this topic
StratPlayer Cone Screws Apr 17 2007, 08:13 PM
John I use a non-worn allen bit to remove them. You ma... Apr 17 2007, 08:20 PM mrhurtalot or do what i did.
strip that shit.
and then dri... Apr 18 2007, 12:22 AM BMartin914 PB Blaster and a set of metric hex sockets are you... Apr 18 2007, 12:34 AM Bartlett 914 If it was put in using loctite then sone heat may ... Apr 18 2007, 05:39 AM vsg914 If they are hopelessly strpped, use a torx bit tha... Apr 18 2007, 05:53 AM 914Sixer New set screws come with some sort of sealant on t... Apr 18 2007, 10:12 AM StratPlayer Thanks for all the advice, I'm letting it soak... Apr 18 2007, 11:50 AM
John
Thanks for all the advice, I'm letting it soa... Apr 18 2007, 11:55 AM TROJANMAN Torx bit, lightly tapped into place ;)
I just did ... Apr 18 2007, 11:59 AM jimtab hex bit, 3/8 drive and an impact driver.....why co... Apr 18 2007, 07:43 PM Tobra
hex bit, 3/8 drive and an impact driver.....why c... Apr 19 2007, 10:13 AM Toast Mine come loose by driving on these crappy So. Cal... Apr 19 2007, 10:20 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd June 2024 - 06:29 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.