 Shift rod separation at tranny |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| jaybird840 |
 Aug 1 2007, 07:10 PM
Post
#1
|
|
Member  Group: Members Posts: 163 Joined: 27-September 06 From: Austin, TX Member No.: 6,927 Region Association: Southwest Region  |
Replacing the NONEXISTENT shifter bushings in my '75 teener and have read and re-read the Pelican article. I have removed the rear tapered screw but was unsuccessful in removing the shift head from the shifter bar in the rear. I wanted to check here before I moved to a bit more persuasion. If they put a cone screw there, I assume that means it separates.... Should just tap off the end of the shift rod with the cone screw removed, right?
--Jaybird  |
   |
 
|
  |
Replies
| Joe Ricard |
Aug 1 2007, 07:42 PM
Post
#2
|
|
CUMONIWANNARACEU Group: Members Posts: 6,811 Joined: 5-January 03 From: Gautier, MS Member No.: 92 |
Could be buggered up from a past removal.
Push it further on and examine the end of the rod. If need be you can use a file to dress up the end. |
|
|
|
Posts in this topic
jaybird840 Shift rod separation at tranny Aug 1 2007, 07:10 PM
r_towle Take the screw out of the part that is on the shif... Aug 1 2007, 07:17 PM swl btdt recently. http://www.914world.com/bbs2/index... Aug 1 2007, 07:35 PM jaybird840 Well, that wasn't so bad.... It actually slid ... Aug 2 2007, 05:56 AM Joe Ricard Did ya lube it?
If it feels like it is binding yo... Aug 2 2007, 06:12 AM
Bartlett 914 Can you change gears at the transmission by hand (... Aug 2 2007, 07:51 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 5th July 2025 - 02:32 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.