Home  |  Forums  |  914 Info  |  Blogs
 
914World.com - The fastest growing online 914 community!
 
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG. This site is not affiliated with Porsche in any way.
Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners.
 

Welcome Guest ( Log In | Register )

> Transmission Oil leak at the shifter console, the rod that goes into the tranny...
purple
post Sep 25 2007, 10:19 AM
Post #1


Pigeon feeders attract me
***

Group: Members
Posts: 938
Joined: 24-July 07
From: Houston, TX
Member No.: 7,942
Region Association: None



Hey Guys, I have yet another issue in this little car... who knew something so simple could have so much go wrong on it?

I have noticed lately that every time I go for a ride, however short, after I park there is a small oil slick under the car. Looks like about a capful of oil comes out of the transmission at the shifter console, as far as I can tell.

The angle drive has a drip too, but it's not major, the console has what I think is the major leak. The wierd part though is that the drip from the angle drive is nasty black oil, and the stuff from what I think is the console is nice and new looking, like the engine oil....wait a minute... shit, i have an engine oil leak now too i guess


anyway, if it's nasty black oil from the angle drive, and i can see nasty black oil off the console, that's tranny oil, right?

The cleanish oil is from the engine. That means i've got a big engine oil leak?

Shit

Well, i was going to replace the oil seal at the shifter console, anyone have any advice on this? Thanks!
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
 
Reply to this topicStart new topic
Replies
purple
post Sep 26 2007, 07:59 AM
Post #2


Pigeon feeders attract me
***

Group: Members
Posts: 938
Joined: 24-July 07
From: Houston, TX
Member No.: 7,942
Region Association: None



I already ordered the seal lotus, so I'm going to replace it. It's just pressing out the roll pin that's the issue for me.

Good call on the goggles Lotus, if i didnt wear glasses i'd do that instead of the safety goggle things. I remember pulling the belly pan to put rack spacers and getting a face full of road gunk and spider nests...not cool.

Good call on the nylon brushes too. I have compressed air quite available from my measly little air compressor, a massive 2 gal unit!
It runs my impact wrench for short spurts, so it's not all bad.

Does simple green do the trick down there? or should i consider some other cleaners?
I have the cap, and the little boot that goes on the cap is coming from JWEST
User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



- Lo-Fi Version Time is now: 11th June 2024 - 07:40 AM