Anyone using QSC 96mm cast Piston & Cylinder Kits? |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Anyone using QSC 96mm cast Piston & Cylinder Kits? |
bobhasissues |
Oct 10 2007, 02:24 PM
Post
#1
|
seemingly endless issues with my 914 Group: Members Posts: 218 Joined: 13-February 07 From: Chicagoland Member No.: 7,532 Region Association: None |
Wondering if anyone (other than Brer, who is selling these kits) has tried the QSC 96mm cast Piston & Cylinder kits. Have read some bad stuff about QSC's cheap Nikasil knockoffs, but nothing about the cast sets.
|
cnavarro |
Oct 10 2007, 03:46 PM
Post
#2
|
Cylinder Guru Group: Members Posts: 472 Joined: 30-December 02 From: Chicagoland! Member No.: 49 Region Association: None |
If I did have to tell someone to use a cast iron cylinder, I would almost always tell them to take an old german cylinder, have it bored out and honed to a set of KB pistons. It's proven and quality, on a budget. Have everything cryo'ed even for a few more $$$ as cheap insurance. Another thing I have done is have had the cylinders all surface ground to the same height groups, allowing you to mix and match cylinders from different groups.
I even take old aluminum 356 cylinders and strip and re-plate them, as "budget" cylinders. There is nothing like an old german casting. |
Lo-Fi Version | Time is now: 10th June 2024 - 04:18 AM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |