 Anyone using QSC 96mm cast Piston & Cylinder Kits? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| bobhasissues |
 Oct 10 2007, 02:24 PM
Post
#1
|
|
seemingly endless issues with my 914  Group: Members Posts: 218 Joined: 13-February 07 From: Chicagoland Member No.: 7,532 Region Association: None  |
Wondering if anyone (other than Brer, who is selling these kits) has tried the QSC 96mm cast Piston & Cylinder kits. Have read some bad stuff about QSC's cheap Nikasil knockoffs, but nothing about the cast sets.
|
   |
 
|
  |
Replies
| rhodyguy |
Oct 11 2007, 09:38 AM
Post
#2
|
|
Chimp Sanctuary NW. Check it out. Group: Members Posts: 22,084 Joined: 2-March 03 From: Orion's Bell. The BELL! Member No.: 378 Region Association: Galt's Gulch |
i worked in a foundry years ago. i hate dirty castings. i realize sand 'trash' left behind from the cores and what not when the cope and drag are closed up, may not 'hurt the runnin' of it'. the old oem 94s are beautiful. even the parting lines are well dressed. must have been a permanent mold production affair. the 'onion' had what must have been am units. just gross! fewer fin count also.
k |
|
|
|
Posts in this topic
bobhasissues Anyone using QSC 96mm cast Piston & Cylinder Kits? Oct 10 2007, 02:24 PM
cnavarro If I did have to tell someone to use a cast iron c... Oct 10 2007, 03:46 PM Jake Raby Typical Chinese quality.
You'll get exactly wh... Oct 10 2007, 03:53 PM
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd June 2024 - 03:46 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.