 replacing floors...orlando florida, need some help / suggestions |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| rufio0205 |
 Nov 8 2007, 12:49 PM
Post
#1
|
|
Member  Group: Members Posts: 134 Joined: 9-September 07 From: Orlando, FL Member No.: 8,099 Region Association: South East States  |
so i am replacing my floors. i have all the pieces necessary. i just need to know if anyone knows how to...i know yeah, cut them out weld them in. that isn't the problem. my problem is that i need to either turn the car on its side or completely upside down. i know i could get a rotisserie. but i cant spend that much money. i know there are places to go that have a lift in the garage bay but i dont know any off the top of my head that i can rent out for a day or whatever i might need. if anyone know of anywhere in the orlando florida area that does this or if you have any suggestions on what to do. please let me know
thomas |
   |
 
|
  |
Replies
| tdgray |
Nov 8 2007, 01:00 PM
Post
#2
|
|
Thank God Nemo is not here to see this Group: Members Posts: 9,706 Joined: 5-August 03 From: Akron, OH Member No.: 984 Region Association: None |
Thomas... you pretty much covered all the ways it can be done but...
You can put the car up on stands or ramps and do it that way...lying on your back and drilling out the ungodly amount of spotwelds. Pretty tough on you though. That said... I would see if you can rent some space somewhere with a four post lift... would go alot faster. sorry no real help as this is a down and dirty job. |
|
|
|
Posts in this topic
rufio0205 replacing floors...orlando florida Nov 8 2007, 12:49 PM
jamara Agreed. Down and dirty. I finished getting my rear... Nov 8 2007, 02:07 PM Al Meredith I am assuming the engine and Xmission and fuel tan... Nov 8 2007, 08:27 PM
Bartlett 914 Spot weld drilling is hard on the arms and elbows.... Nov 8 2007, 09:05 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st August 2025 - 12:37 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.