Home  |  Forums  |  914 Info  |  Blogs
 
914World.com - The fastest growing online 914 community!
 
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG. This site is not affiliated with Porsche in any way.
Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners.
 

Welcome Guest ( Log In | Register )

> Cam gear bolts, How much torque
trojanhorsepower
post Dec 16 2003, 09:46 AM
Post #1


Senior Member
***

Group: Members
Posts: 885
Joined: 21-September 03
From: Marion, NC
Member No.: 1,179
Region Association: None



Any one ... any one ... Buler?

Mine are the allen head kind.

Thanks

-Pete
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
 
Reply to this topicStart new topic
Replies
trojanhorsepower
post Dec 16 2003, 06:30 PM
Post #2


Senior Member
***

Group: Members
Posts: 885
Joined: 21-September 03
From: Marion, NC
Member No.: 1,179
Region Association: None



I have finished tearing everything apart and I posted the #'s for Jake to match up the bearings. Throwing caution to the wind I went ahead and assembled the crank (cleaned everything and matched the bearings back up and got the caps all on there right). If Jake says they are the wrong bearings than I will just take it all apart again.

I called CB and got the torque for the cam gear so I will bolt that on shortly and set the cam timing. If I get the OK form Jake I will put the case back together tonight and start getting all the through bolts set up. May not torque them down till tomorrow, but we shall see. If I can ever get rolling I could have the motor back to long block in a few hours.

-Pete

P.S. Redshift, I bet you wish you hadn’t asked now.
User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



- Lo-Fi Version Time is now: 11th July 2025 - 02:43 PM