 Engine Almost Ready for Install, Put the SS HEs on today |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| EdwardBlume |
 Oct 18 2009, 05:38 PM
Post
#1
|
|
914 Wizard  Group: Members Posts: 12,338 Joined: 2-January 03 From: SLO Member No.: 81 Region Association: Central California 
 |
This engine is close to being ready for install. 2056 with LSD 901. Today, I took off the header stub pipes to the heads and installed Stainless Steel Heat Exchangers.. The left side was tough to get on... but with some persistence I was able to squeeze it on...
I did notice oil seeping through the taco plate and some around the oil filter, but its not enough to leave a drip. Here's some picts... Attached thumbnail(s)  
|
   |
 
|
Posts in this topic
RobW Engine Almost Ready for Install Oct 18 2009, 05:38 PM
Vacca Rabite Why are you going with SSI's over a header?
Z... Oct 18 2009, 06:06 PM
RobW
Why are you going with SSI's over a header?
... Oct 18 2009, 09:53 PM 914Sixer Looking good !!!! Oct 18 2009, 06:35 PM RobW Notice in the first pic how hard the engine mount ... Oct 18 2009, 09:54 PM rick 918-S
Notice in the first pic how hard the engine mount... Oct 18 2009, 10:13 PM tat2dphreak
Notice in the first pic how hard the engine mount... Oct 18 2009, 10:25 PM RobW
Notice in the first pic how hard the engine moun... Oct 19 2009, 09:09 AM hot_shoe914
This engine is close to being ready for install. ... Oct 18 2009, 10:30 PM RobW
This engine is close to being ready for install.... Oct 19 2009, 09:13 AM hot_shoe914
[quote name='hot_shoe914' post='1227552' date='Oc... Oct 19 2009, 10:49 PM Travis Neff You can bend those engine bars pretty easy. I put... Oct 18 2009, 10:37 PM JazonJJordan Several 914 books state that works fine for the st... Oct 18 2009, 11:18 PM jimkelly mark that fan for TDC - real good - before you ins... Oct 19 2009, 07:03 AM rhodyguy i bet the bar will be more verticle when you get i... Oct 19 2009, 09:36 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 22nd May 2024 - 10:38 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.