 Heater Duct Hole plugs?, Weld in? Bolt in? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Cire |
 Oct 31 2009, 07:49 AM
Post
#1
|
|
Member  Group: Members Posts: 279 Joined: 12-March 09 From: Tucson, Arizona Member No.: 10,155 Region Association: None  |
Howdy all,
I pulled out the air duct work along with the controllers and the big center vent thing. Anyway, where all that stuff came out there are holes that go to the cab of the car. Is there a kit with weld in plugs already formed for all the holes? Is there a plastic or rubber boot that goes in those? I am sure I can create something that works but wanted to see if there is anything out there before I start. = ) Also, the air duct tubes in the engine area and in the kick board area... Are there caps for those? I love pictures too. = ) Eric |
   |
 
|
Posts in this topic
Cire Heater Duct Hole plugs? Oct 31 2009, 07:49 AM
pcar9146guy I use the plastic caps from CRC brakeclean or any ... Oct 31 2009, 08:06 AM Vacca Rabite Paint lids. clever. I am going to have to do that... Oct 31 2009, 08:10 AM
gklinger For the holes in the front bulkhead I just used so... Oct 31 2009, 10:29 AM Cire
For the holes in the front bulkhead I just used s... Nov 1 2009, 10:40 PM RobW I use industrial duct taping with super adhesive t... Nov 1 2009, 05:10 AM ottox914 Gp to the plumbing department of your local big bo... Nov 1 2009, 06:31 AM ottox914 Caps installed. Nov 1 2009, 06:32 AM Cire I found a set pre made and ready to install. Slic... Nov 1 2009, 06:48 AM Grelber +1 on the paint can lids. There are different size... Nov 1 2009, 09:02 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 23rd May 2024 - 05:08 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.