 Weber IDF 40 Float adjustment |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| wayne1234 |
 Feb 1 2010, 07:09 PM
Post
#1
|
|
Member  Group: Members Posts: 260 Joined: 6-April 09 From: indianapolis in Member No.: 10,238 Region Association: None  |
Well I'm checking out the "rebuilt carbs from the PO" they have been rebuilt I can tell there are new parts the needles and seats look good but I am questioning the float level how can I measure float level with a caliper I couldnt find much. I have them apart now... lso I read something about the accel pump rod .. is ther a adjustment to that as well....looking for input Thanks
|
   |
 
|
Posts in this topic
wayne1234 Weber IDF 40 Float adjustment Feb 1 2010, 07:09 PM
jmill You take the top off the carb and turn it upside d... Feb 1 2010, 09:40 PM Vacca Rabite With the gasket? Are you sure? In the weber tech... Feb 2 2010, 05:51 AM Joe Ricard I do the measurement from the cover and I eye bal... Feb 2 2010, 06:32 AM Van On the IDFs, you have to put the gasket on before ... Feb 2 2010, 06:50 AM Vacca Rabite Huh, I'll need to open mine up 1mm then. Glad... Feb 2 2010, 08:31 AM jaxdream Use a 10mm hex headed bolt for the one measurement... Feb 2 2010, 08:50 AM McMark The needle valve has a spring to it. Make sure wh... Feb 2 2010, 02:10 PM wayne1234 so do I measure at the "tail" of the flo... Feb 2 2010, 06:57 PM
McMark Check at the furthest point from the pivot. The W... Feb 2 2010, 07:17 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st June 2024 - 09:10 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.