 Engine mount modification, Spread the load |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| LotusJoe |
 Oct 28 2010, 05:20 PM
Post
#1
|
|
Europa Twink Driver  Group: Members Posts: 406 Joined: 30-November 09 From: Southern California Member No.: 11,085 Region Association: Southern California  |
It seems almost every engine I've taken out of a 914 had engine brackets that are distorted and have wallowed holes. So I had my local hydro-cut shop make some new brackets that spread the load and will hopefully stop all the distortion. These are made from 1/4" aluminum.
  I'm going put the first set on my 24 hours of LeMons car. Thanks Joe |
   |
 
|
Posts in this topic
LotusJoe Engine mount modification Oct 28 2010, 05:20 PM
Als914 Great idea Joe!
If you are going to have some... Oct 28 2010, 05:28 PM gothspeed Good idea :) though I would use 3/8 aluminum and b... Oct 28 2010, 05:34 PM
LotusJoe
Good idea :) though I would use 3/8 aluminum and ... Oct 28 2010, 05:46 PM gothspeed
That makes sense. I didn't think about the ba... Oct 28 2010, 05:53 PM 914Sixer I do not think the aluminum is up to the job. Oct 28 2010, 06:37 PM Cap'n Krusty
I do not think the aluminum is up to the job.
M... Oct 28 2010, 07:11 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd June 2025 - 11:19 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.