 914-6 sheet metal questions |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| mepstein |
 Jan 8 2011, 09:48 AM
Post
#1
|
|
914-6 GT in waiting  Group: Members Posts: 19,875 Joined: 19-September 09 From: Landenberg, PA/Wilmington, DE Member No.: 10,825 Region Association: MidAtlantic Region 
 |
Question 1 - I have these 2 pieces. Both were supposed to be origional 914-6 sheet metal. They differ slightly, mainly in the center section. The length is the same, just looks different due to camera distortion. Whick one should I use?
Attached thumbnail(s) 
|
   |
 
|
Posts in this topic
mepstein 914-6 sheet metal questions Jan 8 2011, 09:48 AM
mepstein Question 2- I believe these pieces are not origion... Jan 8 2011, 09:51 AM jt914-6 My factory six sheet metal from the rear...best pi... Jan 8 2011, 09:58 AM jt914-6 The ones in your second post where they are two pi... Jan 8 2011, 10:05 AM mepstein I think your getting my questions confused. The fi... Jan 8 2011, 10:09 AM sixnotfour If you have a 72 or later -6 engine use the top lo... Jan 8 2011, 10:23 AM
mepstein
If you have a 72 or later -6 engine use the top l... Jan 8 2011, 11:38 AM jt914-6 914-6 sheet metal...rear splits in two pieces....o... Jan 8 2011, 10:26 AM sixnotfour Also I think youre installing a 3.2 ?
You will h... Jan 8 2011, 10:38 AM type47 914/6 engine sheet metal pix from ebay
Jan 8 2011, 12:15 PM sixnotfour What does OG stand for?
Original German (Volkswage... Jan 8 2011, 07:28 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 11:58 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.