 Shift Linkage Installation, Must be an easier way |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| damnfiknow |
 Feb 20 2011, 09:44 PM
Post
#1
|
|
Member  Group: Members Posts: 77 Joined: 25-October 09 From: Texas Member No.: 10,980 Region Association: None  |
Just finished my fifth installation of my transmission in the past 2 weeks. I doing this alone so hope to heck I have the clutch throw accurate this time. Needless to say I have got the in and out pretty well down. But, the final step (for me) of connecting the shift rod at the firewall is a bi#ch. I have tried bracing the shift lever in the cockpit to hold in place. No good. I have held the rod with vicegrips at the firewall. Not much better. Any ideas? All of this is at jack stand level. I don't have a lift.
|
   |
 
|
Posts in this topic
damnfiknow Shift Linkage Installation Feb 20 2011, 09:44 PM
r_towle Get someone to hold the shifter....that way it can... Feb 20 2011, 09:53 PM 76-914 I use some needle nose vice grips. The thin jaws g... Feb 20 2011, 10:37 PM silver74insocal is this a tail shift thing? :confused: i hooked m... Feb 20 2011, 11:22 PM
Dr Evil Some are a bitch to get. I just do gymnastics and ... Feb 21 2011, 07:30 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st June 2024 - 11:34 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.