 Single Weber installation, 2 questions |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| EJP914 |
 Apr 24 2011, 08:54 AM
Post
#1
|
|
Member  Group: Members Posts: 260 Joined: 14-June 03 From: Monroeville, PA Member No.: 821  |
1. There is a small wiring harness from the relay board that has 4 wires. The 2 black ones go to the distributor, the green one to the oil pressure switch, the last one has a male metal connector that used to go to the aux air regulator (if I remember right?). Since that part has been removed, where does this last wire go to?
2. Does anyone have any photos they can share that show how you support the accelerator cable? The conversion kit that I bought has an L shaped bracket with a slot on one side and 2 holes on the other. There is no way this can attach to the distributor hold down nut and give the cable a straight shot to the carb linkage. Will I need to make some kind of bracket for the cable? Curious to see how others did this. Thanks for the help. Ed |
   |
 
|
Posts in this topic
EJP914 Single Weber installation Apr 24 2011, 08:54 AM
sean_v8_914 teh aux air valve power wire can now be used to po... Apr 24 2011, 09:01 AM rmital
Does anyone have any photos they can share that s... Apr 24 2011, 09:31 AM sww914 here's 2 Apr 24 2011, 12:32 PM sww914 OOPS! Those are both for dual Webers. I missed... Apr 24 2011, 01:14 PM rmital here's my simple single set-up using the dizzy... Apr 24 2011, 02:41 PM
EJP914 Thanks for the photos and the wiring advice. I now... Apr 24 2011, 07:27 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 17th June 2024 - 01:04 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.