 New valve spring suggestions |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| -JR- |
 Jul 26 2011, 07:25 PM
Post
#1
|
|
Life goes faster at 150MPH  Group: Members Posts: 276 Joined: 12-May 04 From: Victoria BC Canada Member No.: 2,055  |
I need to replace the springs on my 4cyl-2.2L motor.
I don't need anything exotic, IE dual spring. But the cam makes most of of it's power between 2800--> 6500 RPM and any springs should be rated to withstand 6500 RPM. I don't plan on running the motor higher than that and my rev limiter is also set for 6500. I've had pretty bad luck with the motor so far and would like to put a quality set of springs in rather then taking my chances with any "brand X" springs. I only plan to run the motor until October this year before I start my 6 conversion. Otherwise I would probably go for a dual spring setup. There is a So Cal Imports, and the VW/Porsche dealership but that's about it for any specialized parts places. Thanks! |
   |
 
|
Posts in this topic
-JR- New valve spring suggestions Jul 26 2011, 07:25 PM
stugray check Jake Raby @:
http://www.aircooledtechnology... Jul 26 2011, 08:38 PM yeahmag I'm not aware of any single spring setup that ... Jul 27 2011, 12:33 AM
Randal
I'm not aware of any single spring setup that... Jul 27 2011, 10:44 AM Jake Raby We do not have a SINGLE H/D spring thats good past... Jul 27 2011, 12:16 PM -JR- Ordered a set of 130 pound springs from FAT this a... Jul 27 2011, 04:07 PM -JR- Worked two nights this long weekend until 1:00am b... Aug 2 2011, 02:33 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st June 2024 - 01:27 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.