 kconway -6 Conversion Progress Thread, There are a few questions |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| kconway |
 Aug 22 2011, 09:13 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,347 Joined: 6-December 04 From: Monrovia, CA Member No.: 3,231 Region Association: Southern California  |
Getting down to install day. Have a few questions and looking for comments/concerns on whats on the photos.
1. Should the CV/axels be installed on the hubs before trying to put the motor in? I'm running headers if it matters. 2. Same question for the clutch, speedo and throttle cables, first or after? 3. No heat, should those heater tubes be capped? If so, with what? Thanks, Kev     |
   |
 
|
Posts in this topic
kconway kconway -6 Conversion Progress Thread Aug 22 2011, 09:13 AM
campbellcj I'm not sure on the first two Q's. I would... Aug 22 2011, 09:30 AM
kconway
I'm not sure on the first two Q's. I woul... Aug 22 2011, 09:33 AM Ericv1 As I remember, I left my cv axles attached. In re... Aug 22 2011, 10:05 AM smontanaro 3. No heat, should those heater tubes be capped? ... Aug 22 2011, 11:08 AM biosurfer1 I found that a tennis ball blocks those heater tub... Aug 22 2011, 11:14 AM Scott Schroeder Kevin -
I used a rubber cap from my local Lowes fo... Aug 22 2011, 11:16 AM kconway
Kevin -
I used a rubber cap from my local Lowes f... Aug 22 2011, 01:24 PM J P Stein I used to do this on a regular bassis.
Have proper... Aug 22 2011, 11:47 AM 9146986 Lookin' good Kev! Aug 22 2011, 11:54 AM moparrob Kev,
That looks like a really clean install and i... Aug 22 2011, 08:26 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 11th June 2024 - 04:30 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.