 Original OEM 6 engine install question, Front bolt-is there a trick? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Krieger |
 Dec 30 2011, 09:40 AM
Post
#1
|
|
Advanced Member  Group: Members Posts: 4,726 Joined: 24-May 04 From: Santa Rosa CA Member No.: 2,104 Region Association: None 
 |
I temporarily installed the engine in my car yesterday!. I am using a factory oem front mount. Everything lined up great, the bolt went in up through the engine bracket and rubber mount nicely. It was difficult to get the bolt threaded into the nut plate on top. The plate kept moving. The way everything was situated (on my low rise lift) I couldn't get a hand on top to hold it. Is there a trick to doing this? I'm thinking maybe of using some glue/seam sealer to hold it in place.
|
   |
 
|
Posts in this topic
Krieger Original OEM 6 engine install question Dec 30 2011, 09:40 AM
GeorgeRud Tie wrap around the mount? Dec 30 2011, 11:10 AM sixnotfour Does your bolt have the tapered end ? Dec 30 2011, 01:09 PM Krieger I like the tie wrap idea. I have to check next ti... Dec 30 2011, 04:10 PM
rgalla9146
I like the tie wrap idea. I have to check next t... Dec 30 2011, 05:55 PM iamchappy Are you sure you had it positioned right, it sort ... Dec 30 2011, 05:21 PM Krieger I did have it raised to the one of the trans mount... Dec 30 2011, 07:28 PM carr914 I remember when I was putting Steve Gagliones... Dec 31 2011, 06:34 AM rgalla9146
I remember when I was putting Steve Gagliones... Dec 31 2011, 09:25 AM ConeDodger
I remember when I was putting Steve Gagliones... Dec 31 2011, 02:48 PM Krieger I must have been so dang close, plus I was a virgi... Dec 31 2011, 10:58 AM ChrisNPDrider Great way to end the year! :beer2: Dec 31 2011, 02:00 PM carr914
I remember when I was putting Steve Gagliones... Dec 31 2011, 04:48 PM Krieger The front bolt is the original tapered one! I... Dec 31 2011, 06:43 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 7th June 2024 - 09:54 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.