 removal of the starter on 1.8 liter, Having trouble withdrive shaft removal |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| yellowFV |
 Aug 25 2004, 07:19 PM
Post
#1
|
|
Newbie  Group: Members Posts: 33 Joined: 19-July 04 From: Philadelphia, PA Member No.: 2,372  |
Any help out there... I am trying to remove the starter and the lower 17 mm nut/stud comes out easily but it looks like the upper bolt is held in place by a detent in the casting on the starter housing. could not get a socket on it but tried a crows foot wrench and rounded off the bolt head.
Does this starter bolt come off from behind the bell housing ? Any help here..? Should I just be saying the heck with it and pull the whole engine/trans unit down out of the car ? It looks like removing the heat exchanger is difficult and I'm just trying to get the cv shaft clear of the control arm. I was figuring that with the starter out I could clear it. rob |
   |
 
|
Posts in this topic
yellowFV removal of the starter on 1.8 liter Aug 25 2004, 07:19 PM
Eric Taylor Well wasn't porsche so nice when they designed... Aug 25 2004, 07:32 PM
SirAndy yes, this one is tricky ...
the nut is actually o... Aug 25 2004, 07:50 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 4th June 2024 - 04:31 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.