 Rear Bearing, Need to replace. Looking for Guidance |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Hinterleiter |
 Jan 23 2012, 02:33 PM
Post
#1
|
|
Newbie  Group: Members Posts: 6 Joined: 24-September 04 From: Philadelphia, PA Member No.: 2,823  |
Long time reader of this forum, but first time writing. My 74 2.0 needs new rear bearings and since the weather went to crap in the East I decided to look at the job this weekend and was hoping someone would fill me in on the "tricks" to getting it done. Questions concern the removal of the control arm. Looks to me as if I need to remove drive shaft, brake dics/caliper, etc. Question is, do I need to remove the three bolts holding the control arm bearing assembly to remove the control arm? Do I need to remove the heat exchanger? Figure I would ask instead of "re-inventing the wheel" before a dive into it. Any orther tricks I should know about?
|
   |
 
|
Posts in this topic
Hinterleiter Rear Bearing Jan 23 2012, 02:33 PM
rohar If you do a search, you'll find a lot of walkt... Jan 23 2012, 02:48 PM SLITS If you're going to remove the trailing arm:
R... Jan 23 2012, 02:56 PM Eric_Shea I have a few videos on this page if you're pla... Jan 23 2012, 02:59 PM underthetire One of those axle pullers for the FWD crowd sure m... Jan 23 2012, 02:59 PM wingnut86 E. Shea's videos are dead on. Used his method... Jan 23 2012, 04:00 PM okieflyr
Long time reader of this forum, but first time wr... Jan 23 2012, 05:58 PM
Hinterleiter
Long time reader of this forum, but first time w... Feb 6 2012, 01:23 PM matthepcat I would not remove the trailing arm, unless you wa... Jan 23 2012, 06:26 PM rjames
I would not remove the trailing arm, unless you w... Feb 7 2012, 12:07 PM Eric_Shea Normal with stock rubber bushings. You have 85lbf... Feb 6 2012, 01:37 PM bulitt My stub axles popped right out by using a harmonic... Feb 6 2012, 01:59 PM Eric_Shea
Maybe not using the "beat it" method w... Feb 6 2012, 02:31 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 8th June 2024 - 09:53 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.